L76L-M33 Firmware Update with I2C enabled

We are using a L76L-M33 GNSS module and having trouble using its I2C interface. Through the UART interface, we found that the firmware version that the module is using is the following:

$PQVERNO,R,L76LNR13A01S,2023/01/10,11:08*2E

From previous posts such as this one for the L96 module and this one from 3 years ago, it seems that we would need to perform a firmware update to a version that ends with SC. However, we couldn’t find an official source for this version of the firmware or instructions on how to perform the update.

Any help would be appreciated!

Hi Austin,

I will send you L76L I2C firmware through message.

Best regards.

hi @Raphael-Q,
Could you share the firmware to update this for L96-M33 also?

Hi @MinhPhamNgoc
I have sent you the relevant information via email, please check.

Hi @Raphael-Q.
Could I also get the L76-L I2C firmware?

My current firmware shows $PQVERNO,R,L76LNR13A01S,2023/01/10,11:08*2E.

hi @KMohring

I will send you the I2C firmware via email.

Please let me know if you have any difficulty in receiving it

Best regards,

Hello Quectel Support,

I’m using the L76L-M33 GNSS module and my current firmware reports:

$PMTK705,MT3333_AXN5.1.9_MODULE_STD_F1_P1,0007,Quectel-L76L,1.0*08

The module works correctly over UART at 9600 baud and obtains valid GNSS position fixes. However, it does not acknowledge I²C address 0x10.

According to the Quectel I²C Application Note, I²C requires firmware ending in “SC”.

Could you please provide the appropriate I²C-enabled firmware for my exact L76L-M33 module, along with the recommended flashing tool and upgrade instructions?

I would also appreciate confirmation that the firmware is compatible with my current hardware and whether it can be supplied preinstalled for future production orders.

Thank you!

Kamal Ibrahim
RUJ TECH