I am using Quectel’s MC65 to get location info.
Here is my at command process:
1-AT+QGNSSC=1\r
2-AT+QGNSSRD=\"NMEA/RMC\"\r"
The GNSS powers up correctly but I only get +QGNSSRD: OK
in response!
I am using Quectel’s MC65 to get location info.
Here is my at command process:
1-AT+QGNSSC=1\r
2-AT+QGNSSRD=\"NMEA/RMC\"\r"
The GNSS powers up correctly but I only get +QGNSSRD: OK
in response!
Hi Hamid_Rajabi,
Can you get any respones when sending AT+QGNSSRD?(inquire GNSS NMEA sentence)?
Best regards.
Dear Raphael,
The response I get is “+QGNSSRD:” (as it is shown in the picture).
I found the cause of the problem; I had connected GNSS and AUX communication pins wrong.
what I had done(gnss rx>aux rx, gnss tx>aux tx)
what it should have been (gnss rx>aux tx, gnss tx>aux rx)
It works now!