I want to use QENG command with RG500Q-EA without sim card.
However whenever I type QENG command, it shows OK but nothing.
Can it cause because of no sim? or there is something other reason?
These are the log of mine.
AT+QENG=“servingcell”
OK
AT+QENG=“neighbourcell”
OK
Cheers!!
You could try doing a network scan first: AT+COPS=?
Be prepared for that command to take a minute or two to complete.
Thank you for your advice.
Unfortunately, there is no difference whether I run ’ AT+COPS=?’ first or not.
This is the log I’ve done.
AT+COPS=?
+COPS: (1,“KT”,“KT”,“45008”,7),(1,“LG U+”,“LG U+”,“45006”,7),(1,“KOR SK Telecom”,“SKT”,“45005”,7),(1,“450 30”,“450 30”,“45030”,7),(1,“KOR SK Telecom”,“SKT”,“45005”,2),(1,“KT”,“KT”,“45008”,2),(1,“450 12”,“450 12”,“45012”,7),(0-4),(0-2)
OK
AT+QENG=“servingcell”
OK
AT+QENG=“neighbourcell”
OK
Oh I found it out.
AT+QENG=“servingcell”
+QENG: “servingcell”,“LIMSRV”,“WCDMA”,450,05,2241,4820600,10737,313,1,-68,-2,-,-,-,-,-
Thank you so much!!
Dear Sir,
HQuectel_RG50xQ&RM5xxQ_Series_AT_Commands_Manual_V1.2.pdf (1.6 MB) ere is the AT command manual, hope it would be helpful for you.Thanks!
Above is the AT command manual, hope it would be helpful for you,thanks!
