Hello Quectel Support,
I am trying to enable the DR (Dead Reckoning) feature on the LC29HBA module using the QGNSS Tool by sending the necessary commands, but I am not getting any response from the module. Here are the steps I followed:
- Connected the module to my computer via the serial port.
- Launched the QGNSS Tool and established the serial connection.
- Sent the commands as follows:
$PAIR6010,2,10E //open PQTMDRCAL
$PQTMSAVEPAR 5A //Save the PQTM configuration and PQTM commands will take effect after restart
$PQTMDRCAL,1,2,3*5C
- After sending the command, I am not receiving any response from the module.
Could you please provide guidance on what might be causing this issue and how I can resolve it?
Thank you.