L96-M33 - GEO_FENCE pin is always to Gnd

[AntOine80]

Hello,

in the spécification “Quectel_L96_Hardware_Design_V1.4” for the GEO_FENCE pin (N°24) the GEO_FENCE pin (24 for L96 module) is not at High level by default !

I have always 0V on this pin

What should i set up to have the same as the specification ?

Best regards,
Anoine

[Raphael-Q]

Hi AntOine80,

Did you set up geofence by $PQGEO command? I will send you the protocol specification.

Best regards.