I just purchased the L80 – the device works and shows the current latitude, longitude, time, etc., through the serial port in the Arduino IDE. The second thing is that I want to put it into deep sleep mode for, say, 60 seconds. I would like it to wake up for a very short moment after those 60 seconds to retrieve the current location information and then go back to sleep. Is it possible for the wake-up to occur by applying a HIGH signal to one of the L80 pins?
By the way - where can I find the newest Protocol Specification for L80?
Hi @Adam_Sz
Please provide your email address and I will send you the relevant information via email.