Issue with Configuring Data Rate on L89 Module via UART

IoT Modules GNSS Module
1

Dear L89 Forum Members,

I hope this message finds you well.

I am currently working with the L89 GPS module and encountering an issue with configuring the data rate through the UART interface(9600). When I send the data rate command to the module, I receive a response, but the data rate does not seem to be correctly set.

Here is a brief description of the steps I have taken:

  1. I sent the data rate configuration command to the L89 module via UART.
  2. The module responded to the command, indicating that it received the command.
  3. Despite the response, the data rate does not appear to be updated as expected.
2

Hi vignesh1

  1. Which command did you send to switch the module’s baud rate?
  2. What is the command response statement? Can you provide a log?
  3. After you send the command successfully, reset the module to see if the baud rate has changed.