Help New Firmware AT Commands for RM500Q-GL

[Alpha]

Module RM500Q-GL with firmware RM500QGLABR11A05M4G

What does the two following AT Commands do and how to use them?

• AT+QNWCFG=“dis_4MIMO_enable”,(0,1)
• AT+QNWCFG=“lte_earfcn_lock”,(0,1),earfcn1:earfcn2

[Peter.Zhu-Q]

Dear Sir,
These two at commands are just for internal use. Please kindly note it.
By the way, where do you know the at commands？

[Alpha]

@Peter.Zhu-Q

By the way, where do you know the at commands？

In the PDF document included with new firmware RM500QGLABR11A05M4G.

Sir please, what is the proper way to leave each AT Command to stock, 0 or 1?

Thank you.

[Peter.Zhu-Q]

Dear Sir,
Basically you don’t care about these two at commands if you don’t have extra requirements,
and below at commands are just for internal use.Thanks!