GNSS L26-DR default configuration

IoT Modules GNSS Module
1

Hi, I am receiving data via serial terminal and according to the L26-DR_GNSS_Protocol_Specification_V1.1 the default messages from the GNSS are:

ADR: RMC, VTG, GGA, GSA and GLL

but I also receive GSV messages (and my module is ADR), and I get ST messages too but the documentation don´t specify this, is there an error in the pdf?

ST commands:
PSTMANTENNASTATUS, PSTMDRSENMSG, PSTMDRCONFID, PSTMDRGPS, PSTMDRSTYPE, PSTMDRSTEP, PSTMDRUPD, PSTMDRSTATE, PSTMDRCAL, PSTMDRAHRS, PSTMDREPE, PSTMDRSENMSG, PSTMDRDEBUG

thanks

2

Hi，
Yes, GSV is output by default. There are an error in the protocol document. You can also refer to the Hardware_Design document Table 5.

Best Regards