EG25-G Cannot enable ADB with AT command?


I have tried to enable ADB port using command: AT+QCFG=“usbcfg”,0x2c7c,0x125,1,1,1,1,1,1,1

It returns ‘OK’, but when I issue command: AT+QCFG=“usbcfg” in order to check that ADB port was enabled it returns '+QCFG:“usbcfg”,0x2C7C,0x125,1,1,1,1,1,0,1

I have the EG25-G module running on a Raspberry Pi4 with current kernel. The EG25-G has recent had the firmware upgraded (in last few months).

Any help is greatly appreciated.



Hi Snoopy,

ADB port in disblae in firmware. It’s not able to be used in standard module.

Best Regards,