EC25-E disable LTE(4G)

Hello everyone,
Can we set EC25 to do not connect with LTE, only use 3g and 2g, is that possible?

AT+QCFG=“nwscanmode”, 3,1 -> Will that also connect with 3G too?

I mean I want to disable LTE only.
In AT Commands it says only 3. WCDMA only 2. GSM only

Reason is, All base station does not support LTE than connection corrupt if base station does not support LTE. Thanks…

Hello sir, thanks for your question
You can execute AT+QCFG=“nwscanmodeex”, 16 do not use LTE
You can also refer to this picture setting

Hi, thank you for your answer and support.

Hi again, I tried but it shows it is connected to LTE, can you please check?
I also send AT+CFUN=1,1 and check again it still same. It shows it is connected to LTE. Thank you…

Hello, thanks for asking again
EC25 module configuration network search mode command
AT+QCFG=“nwscanmodeex”,16 //LTE only
AT+QCFG=“nwscanmodeex”,28 //GSM,WCDMA,LTE
AT+QCFG=“nwscanmodeex”,12 //GSM,WCDMA

Hi again thanks for you support, after those commands, will it be able to connect internet with 3G?

I also restart it power off and power on again nothing changed.

Hello SmartEq_Bilisim, thank you for your reply
I am sorry that my reply is not clear enough to make you misunderstand.
AT+QCFG=“nwscanmodeex”,16 //means to search only LTE
AT+QCFG=“nwscanmodeex”,28 //means searching for GSM, WCDMA, LTE
AT+QCFG=“nwscanmodeex”,12 //means searching for GSM, WCDMA
If you don’t want to enable LTE, just set AT+QCFG=“nwscanmodeex”,12
This command takes effect immediately, without restarting, thank you.

yes it worked thank you.

Could you please share a link of the “LTE Standard QCFG AT Command Manual”?

It is not listed on your website and it does not show up when searching for it in the Support > Downloads section.

hello iliaspat, thanks for your question
I send LTE Standard QCFG AT Command Manual via email, please check it.

1 Like

Hi Duncan, could you also send me that manual? I searched and could not find it on the website. Thank you!

Hi

Could you please share a link of the updated “LTE Standard QCFG AT Command Manual”?

Hello !
I need documentation on AT commands for EG25-G-GB, I need to set the operation mode to 3G only!
Can you give me a pdf?
my mail is ramilkarataev@gmail.com

Hi Ramil:
I have shared files via email.
You can refer to the AT command:
AT+QCFG=“nwscanmode”

best regards.

Dear Sir:

Please share your email address and I will send you the file.