Does BG96 support ECM mode?

IoT Modules LPWA Module
1

Would like to know if BG96 support ECM mode similar to EC25.

2

up to now ， there is no one cmd to disable or enable ECM feature on BG96 module ，

BTW ， there is this at under BG95 module .

https://cnquectel-my.sharepoint.com/:f:/g/personal/america-fae_quectel_com/Eq0kIvanWZpAjlCcGmABf9wBdFunVLjrsm3344IL63wbrQ?e=Bffjys

3

@Stephen.Li-Q

I’ve updated to the latest firmware, ‘V0204_01.002.01.002’
I’ve set my BG95-m3 module to ECM mode with AT+QCFGEXT=“usbnet”,“ECM”.

I get 3 interfaces on the USB
|__ Port 2: Dev 2, If 0, Class=Vendor Specific Class
|__ Port 2: Dev 2, If 1, Class=Communications
|__ Port 2: Dev 2, If 2, Class=CDC Data

I get a network interface
16: enx----: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UNKNOWN group default qlen 1000
link/ether ----- brd ff:ff:ff:ff:ff:ff
inet 192.168.225.20/24 brd 192.168.225.255 scope global dynamic noprefixroute

I can ping 192.168.255.1, which I assume is the module.

But…I can’t send AT commands to the module anymore over USB, the first USB interface seems to be a serial port, but nothing works on that. How am I meant to send AT commands to the module?