BG95 M# GPIO control

How to control BG95 M3 GPIO output? in the hardware document said"The module provides nine general-purpose input and output (GPIO) interfaces. AT+QCFG=“gpio”*command can be used to configure the status of GPIO pins. For more details about the AT command,please refer to document [2]." note that under development.

however cannot find AT+QCFG=“gpio”* in AT command document.

how can I do this? and for GPIO, first need to set output or input, then for output set high or low. I think it need two step for this or one command with two steps.


I have the same issue. Did you manage to control the GPIO?

Best regards,