BG77 Unsolicitied "+QLWEVENT" messages

IoT Modules LPWA Module
1

Hello,
I’m evaluating the new BG77 (firmware BG77LAR02A02) and have run into an issue. Whenever I register onto a network, I get an unsolicited

+QLWEVENT: 0,“STATE_INITIAL”

message. I can’t seem to find it in the BG77 AT commands manual or how to disable it. I thought it might be the CREG unsolicited message, but CREG? results in +CREG: 0,2. Anyone have any thoughts?
Thank you.

2

Hi lucasholzen,

1,To check register status ,pls send "AT+cereg? ", instead of AT+reg?

  1. URC can not forbidden , But you can set the output direction with below cmd
    image
3

image
image698×170 19.4 KB

4

Hello, is this an updated document? I only have package containing Quectel_BG95&BG77_AT_Commands_Manual_V1.0.pdf and associated Application Notes (that are all also v1.0).