I have an RG801H-EA （Revision: RG801HEAAAR03A03M8G）module that requires the command “AT+QNETDEVCTL=1,1,1” to be sent every time it is powered on in order to establish a network connection. I need it to automatically connect to the network every time it is powered on.
Dear @xinzi_shu
I have sent a latest firmware to you via Message, please check.
After power on, please wait a long and check if it can connect or not.
Dear @xinzi_shu @Toan_Long
Sorry for the late.
As checked internally, module will connect automatically when network switching or loss. When module power on, please execute this command again. This module didn’t support that automatically connect to the network. Currently, this module was EOL on our side, the firmware don’t maintain later, please note this.